18.5. iptables Control Scripts
There are two basic methods for controlling iptables under Red Hat Enterprise Linux:
Security Level Configuration Tool (system-config-securitylevel) — A graphical interface for creating, activating, and saving basic firewall rules. For more information about how to use this tool, refer to the chapter titled Basic Firewall Configuration in the Red Hat Enterprise Linux System Administration Guide.
/sbin/service iptables <option> — A command issued by the root user capable of activating, deactivating, and performing other functions of iptables via its initscript. Replace <option> in the command with one of the following directives:
start — If a firewall is configured (meaning /etc/sysconfig/iptables exists), all running iptables are stopped completely and then started using the /sbin/iptables-restore command. The start directive only works if the ipchains kernel module is not loaded.
stop — If a firewall is running, the firewall rules in memory are flushed, and all iptables modules and helpers are unloaded.
If the IPTABLES_SAVE_ON_STOP directive within the /etc/sysconfig/iptables-config configuration file is changed from its default value to yes, current rules are saved to /etc/sysconfig/iptables and any existing rules are moved to the file /etc/sysconfig/iptables.save.
Refer to Section 18.5.1, “iptables Control Scripts Configuration File” for more information about the iptables-config file.
restart — If a firewall is running, the firewall rules in memory are flushed, and the firewall is started again if it is configured in /etc/sysconfig/iptables. The restart directive only works if the ipchains kernel module is not loaded.
If the IPTABLES_SAVE_ON_RESTART directive within the /etc/sysconfig/iptables-config configuration file is changed from its default value to yes, current rules are saved to /etc/sysconfig/iptables and any existing rules are moved to the file /etc/sysconfig/iptables.save.
Refer to Section 18.5.1, “iptables Control Scripts Configuration File” for more information about the iptables-config file.
status — Prints to the shell prompt the status of the firewall and a list of all active rules. If no firewall rules are loaded or configured, it indicates this fact.
A listing of active rules containing IP addresses within rule lists unless the default value for IPTABLES_STATUS_NUMERIC is changed to no within the /etc/sysconfig/iptables-config configuration file. This change would revert status output to domain and hostname information. Refer to Section 18.5.1, “iptables Control Scripts Configuration File” for more information about the iptables-config file.
panic — Flushes all firewall rules. The policy of all configured tables is set to DROP.
save — Saves firewall rules to /etc/sysconfig/iptables using iptables-save. Refer to Section 18.4, “Saving iptables Rules” for more information.
To use the same initscript commands to control netfilter for IPv6, substitute ip6tables for iptables in the /sbin/service commands listed in this section. For more information about IPv6 and netfilter, refer to Section 18.6, “ip6tables and IPv6”.