 www.centos.org Forum Index CentOS 5 - General Support  Centos 5 vnc remote installation
|
 Bottom  Previous Topic  Next Topic |
|
|
|
|
|---|
Topic options
Threaded
Newest First| Poster | Thread | Rated: 1 Votes |
|---|
|
Centos 5 vnc remote installation | #1 |
|
|---|---|---|---|
|
Newbie
 
Joined: 2006/3/15
From Germany
Posts: 2
|
Hi,
I want to install Centos5 over a vnc remote connection (see http://www.karan.org/blog/index.php/2005/06/15/p35 for an example). It works perfectly for Centos4, but not for Centos5. VNC doesn't start. The installation runs into normal text mode. I have used the following parameters : vnc vncpassword=mypasswd headless ip=dhcp ksdevice=eth0 method=ftp://myftpserver/pub/centos5/ lang=en_US keymap=de Do I need additional parameters for Centos5 ? |
||
Posted on: 2007/5/11 13:56
  |
 |
||
HDaehre
|
Re: Centos 5 vnc remote installation | #2 |
|
|---|---|---|---|
|
Newbie
Joined: 2006/3/15
From Germany
Posts: 2
|
I have found the solution after taking a look at the anaconda sources.
The CentOS5 graphical installation requires approximately 300MB of RAM. If you don't have enough RAM, then the installer loads the smaller installation image (minstg2.img) which only supports text mode. My system had only 256MB of RAM. |
||
Posted on: 2007/5/12 9:40
|
|
||
 Top Previous Topic Next Topic |
 |
|
You cannot start a new topic.
You can view topic.