 www.centos.org Forum Index CentOS 5 - General Support  5.1 installation booted up but then didnot recognized DVD disk that it booted up from
|
 Bottom  Previous Topic  Next Topic |
|
|
|
|
|---|
Topic options
Threaded
Newest First| Poster | Thread |
|---|
|
5.1 installation booted up but then didnot recognized DVD disk that it booted up from | #1 |
|
|---|---|---|---|
|
Peeking in the Member Window
 
Joined: 2006/10/3
From
Posts: 19
|
Dear, all. I tried to install a Linux box with the below specs but after the installation booted up and asked for _language_, _keyboard_, location of the packages to install, I then specified _local_ CDROM (sata) but the initial installation process could not find anything in my _DVD_ ROM. Weird. My DVD drive is a SATA Phillip one and the disk is 5.1 x86_64.
I had to swap out and connect an IDE DVD drive to this box and with the same DVD the installation went OK without asking for language or keyboard and just asked me if I wanted to check the DVD disk. Possbile bugs??? Thanks. 00:00.0 Memory controller: nVidia Corporation CK804 Memory Controller (rev a4) 00:01.0 ISA bridge: nVidia Corporation CK804 ISA Bridge (rev f1) 00:01.1 SMBus: nVidia Corporation CK804 SMBus (rev a2) 00:02.0 USB Controller: nVidia Corporation CK804 USB Controller (rev a2) 00:02.1 USB Controller: nVidia Corporation CK804 USB Controller (rev a4) 00:06.0 IDE interface: nVidia Corporation CK804 IDE (rev f3) 00:07.0 IDE interface: nVidia Corporation CK804 Serial ATA Controller (rev f3) 00:08.0 IDE interface: nVidia Corporation CK804 Serial ATA Controller (rev f3) 00:09.0 PCI bridge: nVidia Corporation CK804 PCI Bridge (rev f2) 00:0b.0 PCI bridge: nVidia Corporation CK804 PCIE Bridge (rev f3) 00:0c.0 PCI bridge: nVidia Corporation CK804 PCIE Bridge (rev f3) 00:0d.0 PCI bridge: nVidia Corporation CK804 PCIE Bridge (rev f3) 00:0e.0 PCI bridge: nVidia Corporation CK804 PCIE Bridge (rev a3) 00:18.0 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1200 00:18.1 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1201 00:18.2 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1202 00:18.3 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1203 00:18.4 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1204 00:19.0 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1200 00:19.1 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1201 00:19.2 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1202 00:19.3 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1203 00:19.4 Host bridge: Advanced Micro Devices [AMD]: Unknown device 1204 01:04.0 VGA compatible controller: XGI Technology Inc. (eXtreme Graphics Innovation) Volari Z7 02:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5721 Gigabit Ethernet PCI Express (rev 21) 04:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5721 Gigabit Ethernet PCI Express (rev 21) |
||
Posted on: 2008/3/8 0:50
  |
 |
||
midair77
|
Re: 5.1 installation booted up but then didnot recognized DVD disk that it booted up from | #2 |
|
|---|---|---|---|
|
Professional Board Member
Joined: 2005/11/29
From Indiana
Posts: 2283
|
Quote:
More likely the SATA interface was not properly recognized, if you would have used linux all-generic-ide it is likely the installation would have worked without the DVD swapping. |
||
|
_________________
CentOS: The Sysadmins choice Congratulations NedSlider |
|||
Posted on: 2008/3/8 1:07
|
|
||
 Top Previous Topic Next Topic |
 |
|
You cannot start a new topic.
You can view topic.