Hello?
i have a problem.when i run this command dh -h i see that the racine partition is not full
[root@svrvrmstest ~]# df -h
Filesystem Size Used Avail Use% Mounted on
/dev/mapper/vg_vrmsstby-lv_root
36G 28G 5.8G 83% /
tmpfs 940M 0 940M 0% /dev/shm
/dev/sda1 485M 38M 422M 9% /boot
/dev/mapper/backup-backup
50G 11G 37G 23% /backups
/dev/mapper/vg_vrmsstby-lv_data
20G 350M 19G 2% /u02
but when i run df -i it show that racine is full. and i can't do anything to the system.
Can u please help me
racine is full
Re: racine is full
If df -i says that it's 100% full then you have run out of inodes (space for directory entries in effect). There is nothing that you can do about this except remove some files/directories - it is not possible to change the number of inode entries except at mkfs time. The problem can sometimes be caused by something allocating thousands/millions of small - perhaps even empty - files under /tmp or /var/tmp or some other directory (those are just the two most likely).
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Re: racine is full
Thanks a lot TrevorH.
I use this link and i works very well.
https://www.interserver.net/tips/kb/sol ... ng-inodes/
I use this link and i works very well.
https://www.interserver.net/tips/kb/sol ... ng-inodes/