I installed Centos on the board.
The version information I am using is as follows.
CentOS 6.5
kernel 2.6.32
The problem is that a hang occurs in the USB Init area during kernel booting.
It happens randomly, not every time.
The kernel log looks like this:
/////////////////////////////////////////////////////////////////////
mpt3sas0: sending port enable !!
atkbd.c: Unknown key pressed (raw set 2, code 0x17c on isa0060/serio0).
atkbd.c: Use 'setkeycodes 7c <keycode>' to make it known.
atkbd.c: Unknown key pressed (raw set 2, code 0x17c on isa0060/serio0).
atkbd.c: Use 'setkeycodes 7c <keycode>' to make it known.
[drm] Enabling RC6 states: RC6 on, RC6p off, RC6pp off
atkbd.c: Unknown key pressed (raw set 2, code 0x17c on isa0060/serio0).
atkbd.c: Use 'setkeycodes 7c <keycode>' to make it known.
atkbd.c: Unknown key pressed (raw set 2, code 0x17c on isa0060/serio0).
atkbd.c: Use 'setkeycodes 7c <keycode>' to make it known.
mpt3sas0: host_add: handle(0x0001), sas_addr(0x500605b00b1d4590), phys(4)
mpt3sas0: port enable: SUCCESS
xhci_hcd 0000:00:14.0: power state changed by ACPI to D0
xhci_hcd 0000:00:14.0: power state changed by ACPI to D0
xhci_hcd 0000:00:14.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
xhci_hcd 0000:00:14.0: setting latency timer to 64
xhci_hcd 0000:00:14.0: xHCI Host Controller
xhci_hcd 0000:00:14.0: new USB bus registered, assigned bus number 3
hold here
/////////////////////////////////////////////////////////////////////
The result of tracking where the hang occurred
A hang occurred in the hcd driver reset function.
I want to solve this problem.
How should I approach it?
Kernel Booting error usb init
Re: Kernel Booting error usb init
Try the same with 6.10. It is more than four years newer than 6.5.