fglrx problem
Posted: 2011/05/26 08:26:37
Dear all,
I have installed CentOS-5.6 as a dual boot on a recent Macbook Pro. I have posted the output of ./getinfo.sh driver in http://pastebin.centos.org/37324. In particular, my graphics card type is Intel HD Graphic 3000.
When I try to launch Ansys-ICEM (cscientific software), I receive the following error:
X Error of failed request: BadLength (poly request too large or internal Xlib length error)
Major opcode of failed request: 65 (X_PolyLine)
Serial number of failed request: 4154
Current serial number in output stream: 4155
As far as I understood, this error is related to a conflict with/of the fglrx-driver, and I should replace the proprietary ati-catalyst driver (11-5) replace by another one. However, since I am a Linux newbie, I am not quite sure about this. Am I correct? And if so, which new graphics driver should I install?
Thank you.
I have installed CentOS-5.6 as a dual boot on a recent Macbook Pro. I have posted the output of ./getinfo.sh driver in http://pastebin.centos.org/37324. In particular, my graphics card type is Intel HD Graphic 3000.
When I try to launch Ansys-ICEM (cscientific software), I receive the following error:
X Error of failed request: BadLength (poly request too large or internal Xlib length error)
Major opcode of failed request: 65 (X_PolyLine)
Serial number of failed request: 4154
Current serial number in output stream: 4155
As far as I understood, this error is related to a conflict with/of the fglrx-driver, and I should replace the proprietary ati-catalyst driver (11-5) replace by another one. However, since I am a Linux newbie, I am not quite sure about this. Am I correct? And if so, which new graphics driver should I install?
Thank you.