Where can I get the drive to the controller B120i for server HP DL360e Generation 8, and what would be the procedure for your installation
thank you
Drive for Controller B120i HP DL360e Gen8
-
- Posts: 9
- Joined: 2013/10/04 15:50:33
- Location: Belo Horizonte MG-BR
Re: Drive for Controller B120i HP DL360e Gen8
Redhat's recommendation is that you put that controller in AHCI mode from its BIOS and use software RAID. It's a FakeRAID controller anyway so you lose very little by doing so and gain considerably by using a tried and tested RAID solution.
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
-
- Posts: 9
- Joined: 2013/10/04 15:50:33
- Location: Belo Horizonte MG-BR
Re: Drive for Controller B120i HP DL360e Gen8
Thank you, TrevorH!TrevorH wrote:Redhat's recommendation is that you put that controller in AHCI mode from its BIOS and use software RAID. It's a FakeRAID controller anyway so you lose very little by doing so and gain considerably by using a tried and tested RAID solution.
I installed centos 5.9, the drive gave an error
Assetino (sector <= 63) at dos.c: 633 in probe_partition_for_geom function () failed
but installed.
After I upgraded to 5.10, is running!?!
Drive for 5.9
http://h20566.www2.hp.com/portal/site/h ... b1e2436bd5
Fórum Brasil
http://www.vivaolinux.com.br/topico/Ser ... L360e-Gen8