Hi All,
First of all, my english not very well. So i'm try to make my question simple and clear.
Below is related device:-
(Internet Service Provider)Unifi router : 192.168.0.253
CentOS IP: 192.168.0.3
In my office all the PC gateway set as 192.168.0.3. And last 3 days, my router was spoiled. And i replaced a new router and set the IP Address same as before that is 192.168.0.253.
But CentOS can't connect to the internet. Unfortunately i lack of CentOS knowledge. Would somebody can help me on my issue? Thanks!
Regards,
Raymond
No internet connection after change router
-
- Posts: 10642
- Joined: 2005/08/05 15:19:54
- Location: Northern Illinois, USA
No internet connection after change router
Why are PC gateway set to 192.168.0.3 if router is 192.168.0.253 ?
-
- Posts: 3
- Joined: 2013/07/25 07:03:39
Re: No internet connection after change router
Hi Clark,
Because centOS are linking other branch if not misstaken. Becuase when i change my gateway to 192.168.0.253, i can't open the other branch share folder.
Because centOS are linking other branch if not misstaken. Becuase when i change my gateway to 192.168.0.253, i can't open the other branch share folder.
-
- Posts: 3
- Joined: 2013/07/25 07:03:39
Re: No internet connection after change router
Ok, i has been tried this command,
[quote]#route add default gw 192.168.0.253 eth1
#wget www.yahoo.com
[/quote]
Ok..it's connected.. but just few second only..After i tried to ping it and it just reply in 40sec..after that disconnected.
[quote]#route add default gw 192.168.0.253 eth1
#wget www.yahoo.com
[/quote]
Ok..it's connected.. but just few second only..After i tried to ping it and it just reply in 40sec..after that disconnected.