I had a 3Ware 9550SX RAID controller in a system that would not load Virtuozzo 3. So I deleted the array created by the 3Ware 9550SX controller before removing it and one drive from the CentOS 4.8 server. Virtuozzo 3 won't allow CentOS 5.x. Even though I deleted the array using the 3Ware utility first when the server boots it shows an error:
ERROR : asr : invalid RAID config table
How can I clear and remove the table without having to reload the OS? Can I? Do I need to run the Seagate Tools and reset the drive?
I don't think a complete system configuration is needed for the question but the motherboard is a Super Micro P4SC8 Intel 3GHz 4GB RAM with a Seagate Barracuda NL750.
Thanks in advance.
SMP Mon Jun 22 12:32:43 EDT 2009 i686 i686 i386 GNU/Linux
00:00.0 Host bridge: Intel Corporation 82875P/E7210 Memory Controller Hub (rev 02)
00:03.0 PCI bridge: Intel Corporation 82875P/E7210 Processor to PCI to CSA Bridge (rev 02)
00:1c.0 PCI bridge: Intel Corporation 6300ESB 64-bit PCI-X Bridge (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev 0a)
00:1f.0 ISA bridge: Intel Corporation 6300ESB LPC Interface Controller (rev 02)
00:1f.2 IDE interface: Intel Corporation 6300ESB SATA Storage Controller (rev 02)
00:1f.3 SMBus: Intel Corporation 6300ESB SMBus Controller (rev 02)
01:01.0 Ethernet controller: Intel Corporation 82547GI Gigabit Ethernet Controller
03:09.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27)
03:0a.0 Ethernet controller: Intel Corporation 82541GI Gigabit Ethernet Controller
Issues related to hardware problems
2 posts • Page 1 of 1