Hi All,
I tried clean install CentOS 7 in servers "HP proliant DL380 Gen9", "UCS C240 M4" and "PowerEdge R320".
After Clicking on Intall CentOS 7, Monitor start displayed showing slanted from left to right and cut in two columns in all three servers.
I tried installing CentOS 7 from troubleshooting option choosing "Install CentOS 7 in basic graphics mode" but still not luck.
Any how with hard working, I installed CentOS 7 in slanted display.
Then I connected server remotely with ssh (this way display is normal) and make changes in grub2 as follows:
Added following lines in file /etc/default/grub
RUB_GFXMODE=1024x768x32
GRUB_GFXPAYLOAD_LINUX=keep
then updated the grub with command
# grub2-mkconfig -o /boot/grub2/grub.cfg
rebooted the server. Still no luck and still displaying in slanted form.
Can you please help me out how can i resolve the display in server.
Thank you very much.
CentOS 7 installation display in slanted
Issues related to hardware problems
Return to “CentOS 7 - Hardware Support”
Jump to
- CentOS General Purpose
- ↳ CentOS - FAQ & Readme First
- ↳ Announcements
- ↳ CentOS Social
- ↳ User Comments
- ↳ Website Problems
- CentOS 8 / 8-Stream / 9-Stream
- ↳ 8 /8-Stream / 9-Stream - General Support
- ↳ 8 /8-Stream / 9-Stream - Hardware Support
- ↳ 8 /8-Stream / 9-Stream - Networking Support
- ↳ 8 /8-Stream / 9-Stream - Security Support
- CentOS 7
- ↳ CentOS 7 - General Support
- ↳ CentOS 7 - Software Support
- ↳ CentOS 7 - Hardware Support
- ↳ CentOS 7 - Networking Support
- ↳ CentOS 7 - Security Support
- CentOS Legacy Versions
- ↳ CentOS 5
- ↳ CentOS 5 - General Support
- ↳ CentOS 5 - Software Support
- ↳ CentOS 5 - Hardware Support
- ↳ CentOS 5 - Networking Support
- ↳ CentOS 5 - Server Support
- ↳ CentOS 5 - Security Support
- ↳ CentOS 5 - Oracle Installation and Support
- ↳ CentOS 5 - Miscellaneous Questions
- ↳ CentOS 6
- ↳ CentOS 6 - General Support
- ↳ CentOS 6 - Software Support
- ↳ CentOS 6 - Hardware Support
- ↳ CentOS 6 - Networking Support
- ↳ CentOS 6 - Security Support