i have a newly installed CentOS 7 system ( 3.10.0-862.3.2.el7.x86_64 ), and having trouble to get the RAID set detected.
RAID card : LSI SAS3801E
RAID set : has finished building, 4TB x 16, RAID 6, size : 52,160 GB
command outputs :
Code: Select all
lspci | grep -i sas
03:00.0 SCSI storage controller: LSI Logic / Symbios Logic SAS1068E PCI-Express Fusion-MPT SAS (rev 08)
05:00.0 SCSI storage controller: LSI Logic / Symbios Logic SAS1068E PCI-Express Fusion-MPT SAS (rev 08)
Code: Select all
dmesg | grep -i sas
plus, i have also installed a driver from here : https://goo.gl/oQu1Lk[ 29.243811] scsi host6: ioc1: LSISAS1068E B3, FwRev=00192f00h, Ports=1, MaxQ=266, IRQ=16
[ 29.284322] mptsas: ioc1: attaching sata device: fw_channel 0, fw_id 8, phy 0, sas_addr 0x1221000000000000
[ 29.312226] mptsas: ioc1: attaching sata device: fw_channel 0, fw_id 1, phy 1, sas_addr 0x1221000001000000
[ 29.337167] mptsas: ioc1: attaching sata device: fw_channel 0, fw_id 2, phy 2, sas_addr 0x1221000002000000
[ 29.360216] mptsas: ioc1: attaching sata device: fw_channel 0, fw_id 3, phy 3, sas_addr 0x1221000003000000
[ 29.384284] mptsas: ioc1: attaching raid volume, channel 1, id 0
there is also an active & running related service :
Code: Select all
systemctl status fusion.mptctl
does it sound like the hardware is ready but i'm missing some additional steps to get it detected by parted ?fusion.mptctl.service - SYSV: This script starts or stops an MPT Fusion (ctl) drivers
Loaded: loaded (/etc/rc.d/init.d/fusion.mptctl; bad; vendor preset: disabled)
Active: active (exited) since Mon 2018-05-28 15:47:32 HKT; 2min 41s ago
Docs: man:systemd-sysv-generator(8)
Process: 2417 ExecStop=/etc/rc.d/init.d/fusion.mptctl stop (code=exited, status=0/SUCCESS)
Process: 2430 ExecStart=/etc/rc.d/init.d/fusion.mptctl start (code=exited, status=0/SUCCESS)
any hints / info would be appreciated. thanks ~