After the 3.10.0-862.2.3.el7 kernel update, the system WOULD NOT REBOOT.
Managed to physically access the system, and attach a PS/1 keyboard, so I could select an earlier kernel.
Rolled back to kernel 3.10.0-693.21.1.el7 was OK for a week or so.
Recently did microcode update, along with a few other patches that were offered via yum.
Now found it randomly crashed, boot failure to dracut. (same as earlier)
Rolled back now to "emergency" kernel 3.10.0.327 - seems to be running OK so far ( only been 2 hours...)
Anyone else having issues with this?
I have firmware P56 and the machine has 5000-series RAID, 18GB ram and dual quad XEONs - Intel(R) Xeon(R) CPU X5450 @ 3.00GHz
HP ProLiant DL380 G5 - killed by last couple of kernels / microcode (??)
-
- Posts: 2
- Joined: 2018/06/04 20:21:34
Re: HP ProLiant DL380 G5 - killed by last couple of kernels / microcode (??)
Same configuration (except using P200 RAID Controller), no issues here. I've updated two machines so far.
-
- Posts: 1522
- Joined: 2014/05/21 20:16:00
- Location: Central New York, USA
Re: HP ProLiant DL380 G5 - killed by last couple of kernels / microcode (??)
Mine with P400 controller is fine and fully updated. (FYI)