Hello Everyone,
I'm trying to perform a CentOS 7 netinstall using CentOS-7-x86_64-NetInstall-1708.iso and a kickstart file. The kickstart file is located on a web server.
After providing the necessary information at the boot prompt, and hitting enter, the installer sends out an LLDP frame to our back-end switch. The back-end switch shuts down the port with state err-disabled.
Is there a way to prevent the installer from sending out LLDP frames during a network installation?
Thanks,
mob
CentOS 7 netinstall shuts down network switch port err-disabled
Issues related to configuring your network
Return to “CentOS 7 - Networking Support”
Jump to
- CentOS General Purpose
- CentOS - FAQ & Readme First
- Announcements
- CentOS Social
- User Comments
- Website Problems
- CentOS 7
- CentOS 7 - General Support
- CentOS 7 - Software Support
- CentOS 7 - Hardware Support
- CentOS 7 - Networking Support
- CentOS 7 - Security Support
- CentOS 6
- CentOS 6 - General Support
- CentOS 6 - Software Support
- CentOS 6 - Hardware Support
- CentOS 6 - Networking Support
- CentOS 6 - Security Support
- CentOS Legacy Versions
- CentOS 4
- CentOS 4 - General Support
- CentOS 4 - Software Support
- CentOS 4 - Hardware Support
- CentOS 4 - Networking Support
- CentOS 4 - Server Support
- CentOS 4 - Security Support
- CentOS 4 - Webhosting Support
- CentOS 4 - X86_64,s390(x) and PowerPC Support
- CentOS 4 - Oracle Installation and Support
- CentOS 4 - Miscellaneous Questions
- CentOS 5
- CentOS 5 - General Support
- CentOS 5 - Software Support
- CentOS 5 - Hardware Support
- CentOS 5 - Networking Support
- CentOS 5 - Server Support
- CentOS 5 - Security Support
- CentOS 5 - Webhosting Support
- CentOS 5 - X86_64,s390(x) and PowerPC Support
- CentOS 5 - Oracle Installation and Support
- CentOS 5 - Miscellaneous Questions