Install Raspberry Pi 3 Model B+
-
- Posts: 6
- Joined: 2018/05/15 18:48:57
Install Raspberry Pi 3 Model B+
Hi.
After recording the image on microsd and then starting it, the following message appears:
After recording the image on microsd and then starting it, the following message appears:
Re: Install Raspberry Pi 3 Model B+
That set of messages with "brcmf" all relate to the wireless card. Are you using that? The wired ethernet port will probably work and you can login at that screen too.
Oh, and which image file did you use?
Oh, and which image file did you use?
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
-
- Posts: 6
- Joined: 2018/05/15 18:48:57
Re: Install Raspberry Pi 3 Model B+
Image: CentOS-Userland-7-armv7hl-RaspberryPI-Minimal-1804-sda.raw.xzTrevorH wrote:That set of messages with "brcmf" all relate to the wireless card. Are you using that? The wired ethernet port will probably work and you can login at that screen too.
Oh, and which image file did you use?
Ethernet cable is not connected, Wi-Fi did not configure
Re: Install Raspberry Pi 3 Model B+
Can you login at the command prompt there and look at the output from the dmesg command and, if possible, copy that up to the forum, or if very large to http://pastebin.centos.org
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
-
- Posts: 6
- Joined: 2018/05/15 18:48:57
Re: Install Raspberry Pi 3 Model B+
http://pastebin.centos.org/768506/TrevorH wrote:Can you login at the command prompt there and look at the output from the dmesg command and, if possible, copy that up to the forum, or if very large to http://pastebin.centos.org
Re: Install Raspberry Pi 3 Model B+
I would suggest downloading https://github.com/RPi-Distro/firmware- ... 5-sdio.txt and replacing the copy of the same file on your system, probably be good to rename the original first - /lib/firmware/brcm/brcmfmac43455-sdio.txt
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
-
- Posts: 6
- Joined: 2018/05/15 18:48:57
Re: Install Raspberry Pi 3 Model B+
Where do I go in order to make a replacement?TrevorH wrote:I would suggest downloading https://github.com/RPi-Distro/firmware- ... 5-sdio.txt and replacing the copy of the same file on your system, probably be good to rename the original first - /lib/firmware/brcm/brcmfmac43455-sdio.txt
Re: Install Raspberry Pi 3 Model B+
The file to be replaced is /lib/firmware/brcm/brcmfmac43455-sdio.txt. The file to replace it with is from https://github.com/RPi-Distro/firmware- ... 5-sdio.txt
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
-
- Posts: 6
- Joined: 2018/05/15 18:48:57
Re: Install Raspberry Pi 3 Model B+
to configure the WiFi network, the package was installed:TrevorH wrote:The file to be replaced is /lib/firmware/brcm/brcmfmac43455-sdio.txt. The file to replace it with is from https://github.com/RPi-Distro/firmware- ... 5-sdio.txt
yum install NetworkManager-tui
after reboot added 3 new lines http://pastebin.centos.org/768516/
Re: Install Raspberry Pi 3 Model B+
But it appears to be working now...
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke