virbr0 and virbr1 not showing in firewall-cmd zones

Issues related to configuring your network
Post Reply
Eniax
Posts: 3
Joined: 2018/07/12 00:59:42

virbr0 and virbr1 not showing in firewall-cmd zones

Post by Eniax » 2018/07/13 04:46:21

I feel like this is a simple issue, but I can't seem to find anything to show it.

I've got three VM's configured, all CentOS 7, on a CentOS7 host.
Two are in the default (virbr0) 192.168.122.0/24 network.
One in (virbr1) 192.168.100.0/24 network.

On the physical host, I'd expect to see virbr0 and 1 in a zone of some sort, but I only have the physical interface, enp3s0.

I've tried to just add the virbr1 to a zone, but it complains that the interface is managed by NetworkManager and it never shows up in the zone. This results in rich rules not being applied.

Thanks for any help.

hunter86_bg
Posts: 1176
Joined: 2015/02/17 15:14:33
Location: Bulgaria
Contact:

Re: virbr0 and virbr1 not showing in firewall-cmd zones

Post by hunter86_bg » 2018/07/18 13:56:45

You should check this one

Post Reply