Page 1 of 1

virbr0 and virbr1 not showing in firewall-cmd zones

Posted: 2018/07/13 04:46:21
by Eniax
I feel like this is a simple issue, but I can't seem to find anything to show it.

I've got three VM's configured, all CentOS 7, on a CentOS7 host.
Two are in the default (virbr0) 192.168.122.0/24 network.
One in (virbr1) 192.168.100.0/24 network.

On the physical host, I'd expect to see virbr0 and 1 in a zone of some sort, but I only have the physical interface, enp3s0.

I've tried to just add the virbr1 to a zone, but it complains that the interface is managed by NetworkManager and it never shows up in the zone. This results in rich rules not being applied.

Thanks for any help.

Re: virbr0 and virbr1 not showing in firewall-cmd zones

Posted: 2018/07/18 13:56:45
by hunter86_bg
You should check this one