I ran some speed test and I was only getting about 183.90 Mbit/s. I have Cetnos 7 and I'm using a bond 5 setup on two nics. Can anyone tell what I did wrong here?
Code: Select all
# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: transmit load balancing
Primary Slave: None
Currently Active Slave: enp7s0
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: enp7s0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: xxx
Slave queue ID: 0
Slave Interface: enp10s0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: xxx
Slave queue ID: 0
Code: Select all
ifconfig
bond0: flags=5187<UP,BROADCAST,RUNNING,MASTER,MULTICAST> mtu 1500
inet xx.xx.xxx.225 netmask 255.255.xxx.0 broadcast xx.xx.xxx.255
inet6 xxxx:xxxx:xx:xxxx:xxxx:xxxx:xxxx:82ff prefixlen 64 scopeid 0x0<global>
inet6 xxxx::xxxx:xxxx:xxxx:82ff prefixlen 64 scopeid 0x20<link>
ether xxx txqueuelen 1000 (Ethernet)
RX packets 80431 bytes 10532048 (10.0 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 27771 bytes 1777900 (1.6 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
enp10s0: flags=6211<UP,BROADCAST,RUNNING,SLAVE,MULTICAST> mtu 1500
ether xxx txqueuelen 1000 (Ethernet)
RX packets 116078 bytes 14807817 (14.1 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 161083 bytes 10309794 (9.8 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 19 memory 0xdf640000-df660000
enp6s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet xx.xx.xxx.226 netmask 255.255.254.0 broadcast xx.xx.xxx.226
inet6 xxxx:xxxx:xx:xxxx:xxxx:xxxx:xxxx:8301 prefixlen 64 scopeid 0x0<global>
inet6 xxxx::xxxx:xxxx:xxxx:8301 prefixlen 64 scopeid 0x20<link>
ether xxx txqueuelen 1000 (Ethernet)
RX packets 1913781 bytes 1564494178 (1.4 GiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 1436042 bytes 1575542289 (1.4 GiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 16 memory 0xdfc40000-dfc60000
enp7s0: flags=6211<UP,BROADCAST,RUNNING,SLAVE,MULTICAST> mtu 1500
ether xxx txqueuelen 1000 (Ethernet)
RX packets 254660 bytes 65000027 (61.9 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 161291 bytes 10329396 (9.8 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 17 memory 0xdfa40000-dfa60000
enp9s0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether xxx txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 18 memory 0xdf840000-df860000
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 4535 bytes 571584 (558.1 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 4535 bytes 571584 (558.1 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Code: Select all
# ethtool enp7s0
Settings for enp7s0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: on (auto)
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes
Code: Select all
# ethtool enp10s0
Settings for enp10s0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: on (auto)
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes