I have setup a NIC bonding with mode=4. Bond interface is up and I'm able to SSH to the bond IP. However the contents of /proc/net/bonding/bond0 file does not have "Active Aggregator Info" paragraph. It looks like this :
Code: Select all
$ cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2+3 (2)
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
802.3ad info
LACP rate: fast
Min links: 0
Aggregator selection policy (ad_select): stable
Slave Interface: em1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 74:a0:2f:42:72:b2
Slave queue ID: 0
Aggregator ID: 1
Actor Churn State: none
Partner Churn State: none
Actor Churned Count: 0
Partner Churned Count: 0
Slave Interface: em2
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 74:a0:2f:42:72:b1
Slave queue ID: 0
Aggregator ID: 1
Actor Churn State: none
Partner Churn State: none
Actor Churned Count: 0
Partner Churned Count: 0
Code: Select all
$ cat /sys/class/net/bond0/speed
2000
Code: Select all
$ cat /sys/class/net/bond0/bonding/mode
802.3ad 4
Code: Select all
Active Aggregator Info:
Aggregator ID: 1
Number of ports: 2
Actor Key: 33
Partner Key: 32781
Partner Mac Address: 00:23:04:ee:c0:94
Thanks,
Prasad