The only thing I can think of that changed was that I did a "yum remove perl/ yum install perl" while I was troubleshooting a perl issue. I'm not sure how that could at all be related, but it's the only event that happened before this stopped working.
What am I missing?
Here is my firewall config:
Code: Select all
[root@mirror ~]# firewall-cmd --get-active-zones
public
interfaces: ens192
[root@mirror ~]# firewall-cmd --zone=public --list-all
public (active)
target: default
icmp-block-inversion: no
interfaces: ens192
sources:
services: dhcpv6-client ssh http nfs mountd rpc-bind ntp mysql https
ports: 3128/tcp 80/tcp
protocols:
masquerade: yes
forward-ports: port=80roto=tcp:toport=3128:toaddr=172.20.3.149
source-ports:
icmp-blocks:
rich rules:
Code: Select all
[root@mirror ~]# iptables-save | grep 80
-A PRE_public_allow -p tcp -m tcp --dport 80 -j MARK --set-xmark 0x64/0xffffffff
-A IN_public_allow -p tcp -m tcp --dport 80 -m conntrack --ctstate NEW -j ACCEPT
-A IN_public_allow -p tcp -m tcp --dport 80 -m conntrack --ctstate NEW -j ACCEPT