Hello!
I am not able to configure the network on a VMWare hosted CentOS.
I am using a router TP-LINK TL-WR841R
I would like to assign a static internal IP address for the VM.
I am aware how to set up static IP address for the VM host, but I am not aware how to do it for the VM itself.
I will be very thankful if some one could help me.
Best Regards,
G. Tsenov
Network Configuration on CentOS7 VM
Re: Network Configuration on CentOS7 VM
Make sure you use bridged networking on the host VM setup and then it's exactly the same procedure on the guest as it was on the host.
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
-
- Posts: 3
- Joined: 2015/02/12 12:06:13
Re: Network Configuration on CentOS7 VM
Thank you for the fast reply.
So I will have to use the same IP/Gateway/DNS configured on the host for my VM network configuration?
So I will have to use the same IP/Gateway/DNS configured on the host for my VM network configuration?
Re: Network Configuration on CentOS7 VM
Most virtualisation methods give you a choice of the network mode that the guests will use. Usually they are known as things like NAT, bridged, Internal only and/or Host only. The internal/host only ones only allow you to talk from the guest to the host and not outside. The NAT version sets up a software "router" in effect that does exactly what your TP-Link router does and sets up an entire NAT network and translates from e.g 192.168.122.0/24 to the real address of the host. The bridged version effectively puts the guests on the same network as the host and you set it up to use an ip address in the same subnet as the host and it acts like it is a separate physical machine on the same LAN as your host.
You can use the NAT version and still assign static IP addresses in the same NAT subnet that the rest of the guests use but you have to alter an xml file and restart libvirt to do so.
You can use the NAT version and still assign static IP addresses in the same NAT subnet that the rest of the guests use but you have to alter an xml file and restart libvirt to do so.
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
-
- Posts: 3
- Joined: 2015/02/12 12:06:13
Re: Network Configuration on CentOS7 VM
Hello Trevor, thank you for the fast reply.
I think I will go with the bridged connection, so I can set 192.168.0.101 for my Host and 192.168.0.102 for my VM - I can do that with the bridged method, correct?
Thank you for the help, I really appreciate it!
I think I will go with the bridged connection, so I can set 192.168.0.101 for my Host and 192.168.0.102 for my VM - I can do that with the bridged method, correct?
Thank you for the help, I really appreciate it!