Hello everyone!
Right after installing a cent-os guest using virt-install and then checking an /etc/sysconfig/network/ifcfg-eth0 file I see that ONBOOT value is set to 'no' by default. Is it away to get it set to "yes" right after installation?
Get a network interface ONBOOT value to be set to 'yes' by default after installation
Re: Get a network interface ONBOOT value to be set to 'yes' by default after installation
If you enable the network during the install then it should be enabled post-install too.
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Re: Get a network interface ONBOOT value to be set to 'yes' by default after installation
Could you please post a relevant virt-install command?